PDLC Smart Film
PDLC stands for polymer dispersed liquid crystal. A PDLC film sandwiches a layer of liquid crystal droplets suspended in polymer between two conductive layers, so a low-voltage signal can switch the layer between light-scattering (frosted) and light-transmitting (clear).
Why PDLC is the practical switchable technology for retrofit
Several technologies can change the appearance of glass. PDLC is the one that ships as a film thin enough to be applied to glass already installed in a building, switches instantly rather than over minutes, and is driven by a simple low-voltage circuit rather than a specialist controller.
In our experience specifying retrofits, PDLC is the switchable technology that most often fits an existing Delaware office, medical suite or coastal home, because it can be applied to glass that is already installed. That is industry context from our own project work, not a manufacturer statistic.
Published PDLC specifications on this platform
These are the figures currently published for the Ghost Glass™ PDLC material we install. They drive the panel layout, the transformer sizing and the lead time on your project.
How PDLC affects the look of the glass
In its frosted state PDLC reads as a soft, even translucency — light still comes through, shapes do not. It is not a blackout product and it is not intended to be. If a room needs darkness rather than privacy, that is a different conversation and usually a different product.
In its clear state the glass reads as glass. There is a slight material presence, as there is with any applied film, which is why we always recommend seeing the material before committing a signature architectural opening to it.
PDLC and UV
The published figure for this platform is up to 99.99% UV protection, which is a meaningful secondary benefit on a partition that gets direct sun — but PDLC is specified for privacy, not as a solar control product. Where heat and glare are the actual problem, a 3M solar control film is the right tool, and we install those too.
Published specifications
Published manufacturer figures for the PDLC material platform we install.
- Working voltage
- 45–60 VAC
- Electricity consumption
- 0.5 W per sq ft
- Maximum cut width
- 5.9 ft
- UV protection
- Up to 99.99%
- Transition
- Immediate
- Application method
- Dry-apply
Low-voltage system fed from a transformer / power supply.
Length is unlimited; wider openings are split into multiple panels.
No moving parts, no blinds, no track hardware.
Installed without a wet water/slip solution.
Frequently asked
What does PDLC stand for?
Polymer dispersed liquid crystal. Liquid crystal droplets are dispersed in a polymer layer between two conductive films; applying low voltage aligns the crystals and the layer switches from light-scattering (frosted) to light-transmitting (clear).
Is PDLC film the same as smart film?
In practice, yes — the switchable privacy films sold as smart film, smart tint or switchable privacy film are PDLC films. PDLC is the underlying material technology; smart film is what the finished product is usually called.
Does PDLC film block heat?
PDLC is specified for switchable privacy, not solar control. The platform we install publishes up to 99.99% UV protection, but where heat and glare are the primary problem a dedicated 3M solar control film is the correct product.
How wide can a single PDLC panel be?
Maximum cut width is 5.9 ft, with unlimited length. Wider openings are covered with multiple panels laid out during the survey so the joints fall on a deliberate line.
Talk through your glass with someone who has measured a few thousand openings
Smart film cannot be priced from a photo — panels are fabricated to your exact openings and the wiring has to physically exist. A short on-site survey turns that into a real number.